Average Reviews:
(More customer reviews)It seems like too much of my limited shop time gets consumed changing the configuration of my various woodworking machines. One of the worst offenders was my old router table that required the removal of the router from the table. Once the router was wrestled free, a pair of wrenches were required to extract a bit and implant a new one. I finally decided to bite the bullet and bought one of the new router lift systems from Jess Em. Integral to this upgrade was the ability to change bits above the table. The Eliminator RC Quick Change Chuck significantly enhances the capability of the Jess Em Table as now a bit change requires only a few cranks on the lift to expose the chuck followed by a quick turn with an allen wrench to loosen/tighten the collett. I have run both small and large bits at varying RPM with no noticable vibrations. Bit performance appears unaffected when tested on numerous hardwoods such as oak, cherry and hard maple. I have my RC Eliminator Chuck installed in a Porter Cable 7518 router motor. Hopes this helps with your decision.
Click Here to see more reviews about: WHITESIDE MACHINE 9700 QUICK CHANGE ROUTER CHUCK - FITS ALL 1/2" PORTER CABLE ROUTERS (EXCEPT #100 & #890)
The Eliminator allows you to change router bits in 5-10 seconds with only one hand and a hex key wrench. Holds bits securely yet eliminates wrestling with wrenches. Leaves one hand free to hold bit in the collet and lessens your chances of nicking or pinching fingers. Chuck accepts 1/2" shank bits directly into collet, use appropriate reducing sleeves for 1/4" shank bit. The Porter Cable version fits models 630, 690, 691, 693, 7518, 7519, 7536, 7537, 7538 and 7539.
Get 35% OFF
0 comments:
Post a Comment