Grizzly C1415 5° Face Cut 3-1/2" Raised Panel Bit, 1/2" Shank Review

Average Reviews:

(More customer reviews)I purchased this bit for panel raising and really like it.
I needed to match a raised panel from a very old desk to make a series of kitchen cabinets, and Grizzly was the only manufacturer that I could find that had a profile that looked like this.
It is a very simple profile and gives a wide reveal.
The bit worked very well. It has a very large diameter, so you will want a powerful table mounted router to spin this thing! I used a 3.25 horsepower Hitachi with variable speed and ran it on the next to lowest speed setting.
The finish was very good. I did minimal sanding on the resultant panel and they look great.
Take very thin cuts. I was working with quarter-sawn white oak and just kept raising the bit in small increments as I made successive passes.
Very nice, I would recommend this bit.
Pat Robinson
"The Man" Installation


Click Here to see more reviews about: Grizzly C1415 5° Face Cut 3-1/2" Raised Panel Bit, 1/2" Shank

Our 3 1/2" O.D. Panel Bits produce a 1 1/4" reveal and are offered in 5 profiles.Use of a 3 HP router is recommended with a router table.Large bits are for heavy-duty use.These bits also have a 10 DEG upshear for quick chip removal.Complete with bearing guide.2mm thick carbide!!For use with a router table.Order G3855 replacement bearing.

Click here for more information about Grizzly C1415 5° Face Cut 3-1/2" Raised Panel Bit, 1/2" Shank