Average Reviews:
(More customer reviews)I bought the MLCS jig, but it seemed to have a minor design flaw. The top plate to the jig needed some spacers so that the jig would properly align, so I had to go to the hardware store to buy a couple nuts to use as a spacer.
Second, one of the plastic tightening almost immediately knobs broke, but was still able to use. I haven't yet replaced.
The instructions for setting up the jig could be a little clearer, but once you know what your doing, you will be ok.
The spacing on the jig could maybe be slightly changed so that measurements would use precisely 1/16 of a inch measurements. ( maybe they were using metric?)
Overall, jig is a useable product, maybe not for high production useage, but I am only using for my own personal projects, and it suited my needs.
Click Here to see more reviews about: MLCS 6406 Pins and Tails Half Blind Dovetail Jig Set
This solid aluminum template and steel jig is machined precisely for creating strong and secure half blind dovetail joints or half-blind rabbeted dovetail joints. This is the perfect solution for sturdy boxes and drawers with the classic dovetail joint design.The solid aluminum template is CNC machined. The steel beams secure both work pieces snugly. Works for 1/2" to 1" drawer sides and 5/8" to 1" drawer fronts (up to 12" in width). Since you cut both sides of the half-blind dovetail joint at the same time, a perfect fit is assured for this joint. Self-spacing edge guides allow proper offset for precise joint alignment. Detailed instruction manual guides you from initial setup through final assembly. 5/8" router guide bushing (not included) is required. 14 Degree Dovetail Bit (1/4" shank) included.
Click here for more information about MLCS 6406 Pins and Tails Half Blind Dovetail Jig Set
0 comments:
Post a Comment